Web Catalogue update October 2019

FOODSTUFF HHS 04 0531 Watertight, synthetic adhesive lubricant with creeping action. Can be used in areas in which food is processed or stored. NSF H1 1 registered 1 In this context, the product may come into incidental contact with food for technical reasons. Very good creeping action. • Lubrication of hard-to-reach areas. • Penetration of very tight spaces and tolerances. Good adhesive properties. • Wide range of applications, e.g. on vertical lubricating points. • Resistant to centrifugal forces on turning and rotating parts. Provides long-lasting protection against corrosion, especially of non-ferrous metals. Water resistant. Resin and acid-free. Silicone and AOX-free. 1 NSF International Corporation Michigan = Internationally recognized organization for the supervision and registration of products used in the food sector.NSF H1 registered (No.: 140816), corresponds to the requirements of H1, 1998. Description Contents in ml Art. No. Pack Qty. Foodstuffs HHS 500 0893 107 6 1/12 Technical data Chemical Basis Synthetic oil with multi- functional additive combination Colour Colourless Viscosity (after the evaporation of the solvent at 40°C) 1251 cSt Base oil viscosity at 40°C 32 mm 2 /s Temperature Range -25 o C to 180 o C Flash Point 200 o C With this information, we want to advise you to the best of our knowledge based on our tests and experience. We shall assume no liability for the application results in individual cases, however, due to the large number of applications and the storage and application conditions that lie outside the scope of our influence. This also applies to the use of the non-binding technical and commercial customer service we provide. We always recommend that you conduct your own tests. We guarantee the consistent quality of our products. We reserve the right to make technical changes and carry out further development. Areas of application: Suited for universal lubrication at high pressure loads, e.g. for chains, racks, joints, levers, bearings, sliding points, cables, open drives, and hinges. Use: Clean the lubricating point and then apply where required. If used in areas in which food is processed or stored, only the technically necessary minimum quantity should be used. NZ. pub. 10/14 ©