Web Catalogue update October 2019

08 0566 RADIATOR SEAL HP Description Contents Art. No. Pack Qty. Radiator Seal HP 150 ml 5861 500 150 12 Protection for all modern, high performance, cross-flow cooling systems. Seals leaks to a maximum of 0.1 mm in the area of cylinder head gaskets and hose connections. • Dirt strainers in cooling circuit do not get clogged. Eliminates evaporation loss in heat exchangers, heater valves, radiators and auxiliary devices. • Enhances operating reliability and protects against engine damage due to loss of coolant. Product effective until the next anti-freeze change. Micro-fine synthetic particles provide sealing effect. No need to drain product. Areas of Use: • In event of microscopic leaks in the cylinder head gaskets and hose connections. • In event of evaporation losses in the cooling system. • Can be used as a preventative measure each time the anti-freeze is changed. • Can also be used on closed cooling systems. • Suitable for all conventional antifreezes and coolants. Application: With the engine warm introduce directly to cooling system. Only put into expansion tank if coolant flows through it. Then allow the engine to run for at least 10 minutes until the thermostat opens and you notice the heater starting to give off heat. Then turn off the engine, re-check the coolant level and top up if necessary. Dosage: Sufficient for 10 litres of coolant. Please note: Wurth Radiator Seal is not a conventional radiator sealant. Conventional radiator sealants must not be used on modern cross-flow cooling systems since the strainers will get clogged; this can result in radiator failure and thus damage to the engine. Oil Fuel Trans Steering Cooling Exhaust Air-Con Intake NZ. pub. 10/14 ©