Web Catalogue update October 2019

BOND & SEAL Application: The application surfaces must be clean, dry, dust and grease-free (see Bond+Seal surface optimization). Material not hardened can be removed with B+S Remover, Art. No. 0890 100 63, while hardened material can only be removed mechanically. Note: Do not bring into contact with alkyd-resin paint systems. Not suitable for glass groove sealing in areas in which UV back reflection can occur. Direct exposure to sunlight can lead to slight surface yellowing. Not suitable for PE, PP, PTFE, silicone rubber, expanded polystyrene and softened plastics. Please keep a minimum adhesive thickness of 3 mm for a secure bond. Technical Data Chemical Basis 1-Component Polyurethane Density (DIN 53479) (Before Hardening) Approx. 1.25 kg/l Application Temperature 5°C to 35°C Skin Formation Time* 45 - 60 min. Hardening Speed* 3 mm/24 h (Moisture-Hardening) Volume Change (DIN 52451) Approx. –5% Shore A Hardness (DIN 53505) Approx. 40 Tensile Strength (DIN 53504) 1.8 N/mm 2 Elongation at Tear (DIN 53504) Approx. 500% Resistance to Further Tearing (DIN 53515) Approx. 6 N/mm 2 Elongation, Compression During Use 10% Volume Resistivity (DIN 53482) Approx. 1010 Ω cm Glass Transition Temperature (DIN 53445) Approx. –45°C Thermal Stability –40°C to 90°C (up to 120 o C for Short Periods) Resistant To Water, Seawater and Limy Water, Public Waste Water, Weak Acids and Alkaline Solutions. Briefly Resistant To Fuels, Mineral Oils, Vegetable Fats Animal Fats and Oils. Shelf Life 12 months (10°C to 25°C) Areas of Application Bodywork & Vehicle Construction. Used in the Building Industry for Bonding & Sealing of Wood, Stone and Concrete Joints. Combined Tensile & Shear Strength (DIN 53283) > 1 N/mm 2 Tear Propagoetian Strength (DIN 53515) +7.0N/mm 2 Recovery (DIN 52458) +90% 05 4216 * measured at 23°C / 50 % rel. humidity This information is only a recommendation based on our experience. Please mark our B+S optimization table in this context. Preliminary testing required. For further information see technical data sheet. Instructions for Use: • Once opened, the package of sealant must be used the same day. • Avoid three-point adhesion: When applying a sealant, care must be taken to ensure that it adheres to no more than 2 edges. If there is a third point of adhesion on a substrate, stress cracking can result from movement and a 100% seal of the joint can no longer be guaranteed. The joint should be filled with back-fill material to avoid three-point adhesion. Edge 1 Sealant Edge 2 Substrate Back fill material Correct Application: NZ. pub. 10/14 ©