Web Catalogue update October 2019

05 4063 OPERATING INSTRUCTIONS FOR REPLAST EASY ADHESIVES Spray the areas to be stuck together with plastic cleaning agent and allow agent to act for 2 minutes. Then wipe with a clean, dry, non-fluffy cloth. To avoid any parts from tearing, using a suitable drill, please drill a hole at the end of the area to be repaired. Cut or mill out the front side of the tear in a V shape. Sand down the front and rear of the area to be repaired using sandpaper P180. Avoid heating up the area being sanded. Apply a thin layer of plastic primer and allow to air for 2 minutes (at 23°C). Carefully press the reinforcement tape with the adhesive onto the rear of the area to be repaired until the adhesive squeezes through the tear and onto the front of the object. Smooth excess adhesive using the contour foil and spatula. Cut the self-adhesive reinforcement tape to the size of the repair. Apply the adhesive directly to the reinforcement tape. Pleae make sure that the tip of the mixing tube always remains in the adhesive so that air bubbles are not formed. Depending on the sort of repair use plastic adhe- sive. Universal or plastic adhesive Fast. To achieve a homogenous 1:1 mixture during the processing of the adhesive, squeeze out 1-2cm of the product and then start with the gluing process. After the adhesive has hardened, sand the surface using coarse P180 sandpaper. Avoid heating up the area being sanded. After using fine sandpaper P320 to smooth the area, the surface can be primed and varnished (please notice the instructions provided by the varnish manufacturer). NZ. pub. 10/14 ©