Web Catalogue update October 2019

05 3151 NZ. pub. 04/16 © GRAVEL THROW AND UNDERBODY PROTECTION Chemical Basis Solvent, Resin, Rubber Density (20 o C) DIN41757 Ca.l, o4 kg/l Removable with Solvents (uncured), Mechanical (cured) Dilution Solvents Solids Content (DIN 53216) Approx. 51 % Viscosity (20 o C) Approx. 48 Pa.s Temperature Resistance (cured) -40 o C < T < 90 o C Resistant to Water; oil; mild acids & bases Coverage + 0.7 l/m 2 Drying times: Touch Dry (20 o C, 65 % humidity) Completely dried (20 o C, 65 % humidity)+R 60 o C + 45 min ( + 700 µm wet) + 2 h (+ 700 µm wet) Salt spraytest (DIN 50021) 480 h @ 350 µm dry film thickness 720 h Shelf Life 24 Months Oven Drying (40 o C T < 60 o C) + 1 h Partner Products: UBS Gun UBS Cup Gun Rubber-based coating mass which can be painted over, contains solvents. Very good adhesion, quick skin formation. Scratch-resistant. Suitable for painting over . With all conventional solvent- and water-based one- and two-component top-coat paints. Suitable for oven drying at 40°C to 60°C. Very easy sanding after through-drying. Professional Tips: • Different textures can be sprayed by changing the distance and pressure. • Covering with a clean top-coat paint darkens the colour underneath. Colour Content in ml Art. No. Pack Qty. Black 500 0892 075 250 1/12 Black 1,000 0892 075 200 1/12 Areas of application: For repair and restoration of the original texture and for protection against stone chips and corrosion in all visible areas, e.g. front and rear valances, side skirts, bumpers and chassis of cars, trucks and buses. Excellent for use as anti-drone mass for wheel wells and chassis. Note: Do not spray on joints, engines, transmissions and brake systems. Turn can upside down and spray until valve is empty after use. Cannot be mixed with thinners, water or paint. The product can be painted over within 24 hours. Sanding and cleaning is required before painting over. This information is only a recommendation based on our experience. Preliminary testing required! While using the product, both the technical data sheet and the specifications of the applicable regulations are to be complied with. Technical Data: Use: Shake well before use. The subsurface must be clean, dry and free of rust and dust. Make the first coating very thin for better adhesion and let it flash off for approx. 3 minutes. Then apply the desired coating thickness. Allow each intermediate coat to flash off. Depending on coating thickness, can be painted over after approx. 60 – 120 min. Working pressure: Max. 3 bar Optimum spraying distance is 30 cm. The best spraying results are achieved at a processing temperature of 15 – 25°C.