Web Catalogue update October 2019

DOS MOTOR SEALANT 05 1514 • High temperature resistance. • Seals reliably up to temperatures of +280°C. • Pressure resistant up to 700 bar. • Also suitable for high pressure lines and pressure chambers. • Excellent adhesion. • Seals glass, ceramic and metal surfaces permanently and securely. Replacement for solid engine seals on pressure chambers as well as screw connections. Resistance List: The engine sealing compound MOTOR SEALANT has good resistance to the following media: Engine oil, transmission oil, hydraulic oil (mineral, synthetic), diesel fuel, heating oil, coolant, brake fluid, waste water, alkaline lye, formic acid, alcohols (methyl, ethyl, etc.), ethyl acetate, acetone, chlorinated solvents, phosphoric acid (10%). Gases: Acetylene, carbon dioxide, propane, sulfur dioxide, hydrogen. Due to space limitations this list is incomplete and restricted to the most important media. A complete list is available upon request. Note: The above information is intended as a recommendation only, based on our experience. As a matter of principle, we recommend that you carry out your own tests. Application: Step 1: Clean and dry the surfaces to be sealed. Step 2: Apply a thin layer of the material on one side and leave for 5-20 minimum to air. Step 3: Then join two surfaces. Thermal hardening possible from +60 o C. It is relatively easy to separate the joined parts if necessary. Caution: Not suitable as cylinder head gasket. Technical Values Components 1 Base Resin Specific Weight at +20°C 1.08 Film Formation, Pot Life 5–7 minutes Thermal Behavior –50 °C to +280 °C Pressure Tested up to Approx. 690 bar Viscosity in mPas Approx. 5,000–13,200 pH Value Approx. 7 Shelf Life 1 Year Total Deformation 25% Contents Art. No. Pack Qty. 50g 0893 260 100 1 NZ. pub. 10/14 ©